WINTER HOURS**

Tues to Friday 12pm - 5pm

Sat 12pm - 4pm 

CLOSED SUNDAY & MONDAY YEAR ROUND.
** I am a ONE person shop through the winter. I work on bikes in the morning, and open shop in the afternoon. 

ADDRESS

131 MCPHILLIPS AVE
SALT SPRING ISLAND, BC 
V8K 2T6
 
P: 250 931 BIKE (2453)
E: outspokinbikeshop(at)gmail.com

FIND​ US

© THE GYM Ltd. all rights reserved.

SERVICE RATES
Shop Rate: $60/hour

 

MINOR TUNE UP ($49.99) (For qualifying bikes only) : Frame and chain wipe, Brake / Shifting cable lube and adjustments, hub, headset, bb bearing check and minor adjustment, hardware check, minor wheel true. $49.99
REGULAR 50 POINT TUNE UP W/ CLEAN ($69.99) :  solvent clean of drive train, wipe / inspect frame, set-up/adjust/torque/lube everything, wheel truing (including spoke tension adjust), limit check, hardware check, BB adjustments, Brake Pad / cable / housing labour, Cup / Cone bearing adjustments,  tires inflated, and more (see our 50 point inspection sheet at the bottom of this page). (Bike Detailing $15 extra)
MAJOR TUNE UP ($89.99): If your bike is two tune ups or more overdue, or has been exposed to the elements for an extended period of time, it will require more time to service than the average bike. This tune up package is the same as the regular, but with additional time tacked on. 
OVERHAUL ($139.99) REG Tune Up PLUS repacking/replacing of headset, bottom bracket and wheel bearings plus a 50-point tune-up: 

 

SUSPENSION TUNE ($149.99): Regular Tune Up PLUS Lowers and Air Can Service 
*IMPORTANT - HEAVILY NEGLECTED OR POOR QUALITY (BOX STORE) BIKES MAY REQUIRE EXTRA SHOP TIME. IF A PART BREAKS DURING SERVICE, FOR REASONS BEYOND OUR CONTROL AND A TASK THAT WAS SCHEDULED TO TAKE 10 MINS TAKES 30 MINS, THE ADDITIONAL LABOUR IS BILLABLE TO THE CUSTOMER.
A LA CARTE
Bike Wash: $15
Drive Train Clean - $20
Drive Train Replacement $30
Gear cable or brake pad installation / adjustment: $15
Wheel truing: $15-30 (for most bikes)
Spoke Replacement and true: $30
Tube/Tire replacement: $10.00 for regular bikes, $20-30 for some e-bikes
Repacking Bottom bracket: $25.00
Replace Bottom Bracket: $20
Chase Bottom Bracket threads: $20
Overhaul Headset: $20.00-$30.00
Replace Headset : $35
Overhaul Front Hub $20.00
Overhaul Rear Hub $25-30.00
Chain Install: $15  (includes test ride)
Cassette Install $15
Wrapping Fender install: $35
Rack Install: $15
Kickstand Install $8
Saddle Install - $8
Bar Tape $15
Hydraulic brakes bled (includes fluid) $30.00 each
Assembly of boxed bike $45
*Tune Up Check List

  • Check bike for obvious signs of wear / problems
    • Cracks in frame
    • Damaged housing, cables, parts
    • Worn chain, sprokets
    • Bent derailleurs hangers / play in derailleur
  • Check rear wheel
    • Tire – condition?
    • Rim – worn? Dished?
    • Trueness / Spoke Tension
    • Hubs – play or spinning rough
    • Rim Brake - pad align. / wear?
    • Disc Brake – pad wear, rotor true?
  • Remove Rear Wheel
    • True / tighten if necessary
    • Adjust Hubs if necessary
    • Clean Rim
  • Clean:
    • Rear triangle, drop outs, and Bottom Bracket shell
    • R.derailleur and f. derailleur
  • Re-check clean frame for cracks
  • Re – install Rear Wheel
    • Make Sure axle is fully seated in drop out
    • Re-attach brake
    • Re-check hanger alignment
  • Clean Chain
  • Rear Brake
    • Lube cable and caliper
    • Check B-pad alignment / TORQUE!
    • Replace b-pads if necessary
    • Replace frayed / kinked cables
    • Inspect housing
  • Front Derailleur
    • Inspect / lube or replace cables and housing
  • Lube Rear and Front Derailleur pivots
  • Check Pedals are secure
  • Check BB for play
    • Feel for bearing wear
  • Set Rear limits
  • Adjust Rear Cable Tension
  • Set front limits
  • Adjust Front cable tension
  • Tighten F.D bolt
  • Torque to specs stem bolts (fill in form)
  • Torque to specs handle bar bolts (form)
  • Torque to specs brake pinch bolts (form)
  • Torque crank bolts to 40nm
  • Front Wheel
    • Tire – condition?
    • Rim – worn? Dished?
    • Trueness / Spoke Tension
    • Hubs – play or spinning rough
    • Rim Brake - pad align. / wear?
    • Disc Brake – pad wear, rotor true?
  • Remove Front Wheel
    • True / tighten if necessary
  • Adjust Hubs if necessary
  • Clean front Fork
  • Re-install f. wheel
  • Check Headset for Play – tighten if necessary
    • Feel for bearing wear
  • Quick Releases secure / Nuts to 40nm
  • Inflate Tires
  • Test Ride
  • FILL OUT CUSTOMER FORM in full
    • inlc. PARTS and Recommendations